- Up to 2500 nodes on the local power grid
- Up to 3 miles between nodes
- Installs without any setup - auto connecting auto healing mesh network pre-configured at factory per site
- Load / Lighting control up to 4KA, 80-480VAC with power monitoring
- 0-10V dimming (sink or source up to 30ma)
- One input/output (programmable function) wire pair with 12V power @ 50ma
- Industry leading 256-bit elliptic curve cryptographic security
Network
- G3-PLC (ITU-T G.9903) standards based and certified.
- OFDM based IPV6 Auto Connect / Auto Healing Mesh network
- 4 - 121.9KHz CENELEC Band
- 40Kbps minimum data rate
- 3-mile range between nodes
- 255 nodes per cluster with one DC1 data concentrator
- PLS-DC1 can connect directly to the SCADA system via local Ethernet
- Alternative Cellular or WIFI connection supported by PLS-DC
Security
- 256-bit Elliptic Curve Cryptographic security between nodes and data concentrator
- Secure TLS/SSL based connection between data concentrator and operator terminal (SCADA)
- Biometric and two factor authentications at the operator terminal
Power
- 80 – 480VAC, 50-60Hz, Single phase
- ANSI C136.37 surge requirements compliant
- Fully protected against transients and brownouts with EN55022 Class B isolation
Load Control & Metering
- IEC 600335-1 compliant latching relay
- Nominal switching capacity: 4KA, 480VAC, inrush capable
- Max switching power (resistive load): 4.432KVA
- 6" long 14GA pigtails for Line & Neutral
- 6" long 20GA pigtails for 0-10V dimming
- 5% accurate energy metering
- Active power, true RMS current, RMS voltage, Line frequency and power factor metering
Lighting Control
- 0-10V analog dimming output 30ma sink/source
- Built-in energy metering of connected lighting load
IO
- 12V power wire @ 50ma
- Programmable input (active low open drain) or output (open drain)
Mechanical
- 3in dia x 1.5 in tall [76 mm dia x 38 mm tall]
- IP66 protection level
- -40°C to +75°C Operating temperature